The M-DL-ADAPT ‘letter-box’ adapter can be fitted to any dLive or Avantis I/O Port to enable the use of certain iLive / GLD option cards e.g. M-Dante, M-MADI or M-Waves. It provides a 64x64ch 48kHz interface with built-in Sample Rate Conversion.

Fitting the adapter

1. Switch the system off.
2. Remove the 4 screws securing the I/O Port blank panel on the dLive MixRack / Surface or Avantis mixer. 
3. Slide the adapter into the slot and press it firmly into the mating connector.
4. Secure the adapter by tightening the 4 thumb screws.

Fitting the option card

1. Switch the system off.
2. Remove the 2 screws securing the blank panel over the adapter ‘letter-box’ slot using a star Torx T8 screwdriver.
3. Slide the option card into the slot and press it firmly into the mating connector.
4. Secure the card using the 2 screws.

Setting clock and patching signals

Use the I/O screen to patch signals from or to the I/O Ports.

Use the Audio Sync screen to select the clock source. Set this to Internal on the clock-leader system, or to the relevant I/O Port on all other networked (clock-follower) systems.

The functions of the adapter and option cards are determined by the firmware (operating software) that the dLive  or Avantis system runs. Firmware is updated regularly as new features are added and improvements made.

ⓘ Check www.allen-heath.com for the latest version of firmware.

For more information on setup and functions please refer to the dLive or Avantis Firmware Reference Guide s available at www.allen-heath.com.