Introduction
The QU-3-RK19 Rack Kit enables mounting of the Qu-3 or Qu-3D in a standard 19” rack.
A minimum 10U of rack space is required for mounting, with extra space required at the rear for connections. Allow for adequate ventilation around the mixer when mounting and do not impede airflow to the fan located on the underside.
Use only the supplied fixings to attach the rack ears to the Qu. Using other fittings may cause damage to the unit or ears.
Supplied with QU-3-RK19:
- 2x Rack Ears
- 6x M4x8 Torx® fixings
Attaching the ears to the Qu-3 or Qu-3D
- Place the Qu face down on a padded surface, taking care not to place pressure on the faders or encoders.
- Line up the rack ears with the unused screw holes at either side of the mixer.
- Secure each rack ear using three of the provided M4 Torx® screws.
- Turn over the mixer and attach the ears to rack rails using all 8 available fixing points.