The RPS11 [1] is a linear power supply for the GL Series [2]
(GL2400 [3], GL2800 [4], GL3800 [5])
Veteran Products:
The RPS11 can be used as an alternative power supply for the
following discontinued products ML3000, GL4000, GL4800
or the RPS11 3...
Auxiliary output sockets (AUX 1-6) would usually be used for
connecting to an FX unit input,
with the signal levels sent to the FX unit governed by the AUX SEND
pots from each input channel,
setting the AUX MASTER at a level that will prevent peak signa...
Pre-Mute Direct Outputs are not a standard jumper option on the
GL2400 mixer.
It would be possible to individually modify each channel to hard-wire
the direct output to a pre-mute status,
but this would be a custom-modification which would not be carri...
GL2400 / MPS12 PSU as;
Power Consumption = 90W
Power Output = 80W
Available to order via your dealer or local Allen & Heath distributor
[1]
PART NO. DESCRIPTION
AP6449 DUST COVER GL2400-16
AP6450 DUST COVER GL2400-24
AP6451 DUST COVER GL2400-32
AP6452 DUST COVER GL2400-40
keywords: accessories accessory soft d...
The GL2400 832 can be regarded as the absolute limit.
GL2400 832
+/-16v = 1.4A
+10v = 660mA
Sys-link add 50mA +/- rails
Full balanced option add 50mA +/-
GL2400 424
+/-16v = 1.2A
+10v = 660mA
Syslink add 50mA +/- rails
Full ...
We always advise keeping your original box and packaging,
should you need to move or ship the desk in the future
you will have a box that is designed specifically for this purpose.
To order a replacement please contact your dealer or local distributo...
Many Allen & Heath products can have their busses linked so as to
expand input/output capability.
We call this Sys-Link(tm) and it requires the purchase and fitting of
special PCBs to each mixer.
The signals are presented on D connectors on the rear of...
The Master and Slave both require their own distinct Sys-Link(tm)
option card. - Please see attached chart
If you have any questions please contact your dealer or local Allen &
Heath distributor [http://www.allen-heath.com/distributors]
keywords: SysLink...
To configure your Allen & Heath desk for use with an external FX
processor carry out the following steps.
* Connect an Aux* output to the mono or left input of your external
FX processor.
* Connect the stereo LR returns from your FX processor to a s...