RSS Feed
Knowledgebase : Discontinued Products > DR128 / DR66 / DR Switch
Q. Can DR128s or DR66s be linked to increase the number of inputs/outputs yet remain controlled as a single unit? A. DR128 and DR66 do not feature digital interconnection between units, so there is no access to the digital equivalent of the mix bus...
Q. I have a DR unit that had V2 software pre-installed, but I want to use a V1 configuration file. Can I install V1 software instead? A. Yes, you can, but it will need to be V1.83 (the latest V1 software release) which you can download from the Sof...
Q. I need a 20m RS232 cable from my DR66 to my laptop. Is this possible? A. The maximum recommended length of the data cable between the PC and the DR unit is 5 meters. This is because the RS-232 is an unbalanced connection, and the signal will be sub...
A pair of rack ears are provided with the Should you need to order more, please order through your dealer or local Allen ">part code - description AA3150-L - RACK EAR DR66/GRO5 LEFT AA3150-R - RACK EAR DR66/GRO5 RIGHT keywords: Rackears Rackmount R...
IMPORTANT NOTICE: THIS SHOULD BE PERFORMED BY A SERVICE ENGINEER ONLY If the RS232 Serial Port is not working on your DR66 [1] / DR128 [2] unit, there are some steps you can follow to try to remedy the problem. 1) Ensure that the firmware is the ...
Q. I have an early model DR unit. Can I update it to run the latest software? A. Yes you can. All DR units are compatible with the latest versions of software. Please note that if you want to use the optional Sys-Net port that was previously use...
The PL-12 wallplate [http://www.allen-heath.com/ahproducts/gr2/] is only for use with the GR2 analogue zone mixer and the optional PL-5 infra-red hand-held controller [http://www.allen-heath.com/ahproducts/pl-5/] note: This product is not compatible wit...
Q: I have been asked to adjust the setting on a DR66 mixer and need the software to do it, I had a look on your website but couldn't find any links for the software. Could you please send me the software or a link for it? A: The DR66 and DR128 are legac...
Q. With the new Version 2 software, can I run WinDR and also have Sys-Net control at the same time? A. With the early releases of V2 software (V2.00, V2.01) this is not possible. You would need to disconnect WinDR to enable Sys-Net control and vice-ver...