RSS Feed
Knowledgebase : ME System
(24)ME-1
(7)ME-U
 

Adds support for the ME-U Personal Mixer hub [1]. Note: The ME-1 [2] mixer must run firmware version V1.10 or higher to work with the ME-U hub. http://www.allen-heath.com/software [3] 27th Sept 2013 keywords ME1 MEU V.1.10 File download: A...
We have recommended certain peripheral hardware devices and verified they worked at the time of testing.* * Please take into consideration the fact that these devices are made by 3rd party manufacturers, and the specifications of components can change, ...
The following are ME-1 system latency measurements using 'input direct out' as the source and the 'Monitors' output on GLD. GLD / dSNAKE: AR2412 Input to ME-1 Output: 1.21 ms GLD / Aviom mode: AR2412 Input to ME-1 Output: 1.21 ms iLi...
August 2013. V1.01 Firrmware available to download on the ME-1 product page [1] or at www.allen-heath.com/Software [2] Improvements:  Improved support for Aviom® Pro16® system  Aux In headroom increased  Fixes several other minor issues New f...
Q: Our customer uses 2 iLive systems with 2 MixRacks and 2 consoles in FoH+Monitor mode. He is going to use ME-1 system [1]. So is it possible to connect in this system ME-1? If yes - then how? A: If he is using 2 iLives in FOHMONS then probably he ...
Version 1.01 - Maintenance release. October 2013 < File download: AllenHeathMEU_V1.01-Rev12139.zip > [1] Issues fixed: ID_87: ME-1 even key settings could be reset after the ME-U rebooted following an IP address change using its setup applicatio...
Update - An error has been detected with this maintenance release that did not fully fix the issue with ME-U. Maintenance Release V.1.94 will be available ASAP (20.01.14) V1.93 is a maintenance release of iLive firmware and Editor software. Vers...
For parallel connection of multiple ME-1 mixers, a Layer 2 network switch can be used, provided it supports Fast Ethernet (100Base-TX) connections. Layer 3 & 4 protocols including Spanning Tree, Tagged Egress Packets, and Broadcast Storm Protection can ...
Allen & Heath can provide a range of pre-assembled, approved CAT and fibre cables. Please see here [http://www.allen-heath.com/ahproducts/cat5/] for more information. Recommended Cables for A&H digital mixers Different cables are used with our mixers d...
ME-1, the GLD Monitor Out, M-MMO card and MultiOut module are compatible with the original Pro16 protocol. Compatible AVIOM products include the A-16II personal mixer (but not the older A-16 mixer, nor the new A360), AN-16/I Input interface, and A-16D P...