Knowledgebase: GR Series > GR05
GR05 User Options - Jumpers
Posted by on 11 February 2014 02:19 PM

 

For more infomation please see user guide for more details   <here>


Line Inputs 3,4,5
Internal jumper links to set the sensitivity for high level +4dBu or low level –10dBV equipment. 
Check for correct signal level using the meter LEDs.

30dB Attenuator Pad

 

Microphone Input 1,2 Connectors
For high output microphones or line level sources set the internal jumper links for pad selection. 
The sensitivity of the input stage is matched to the microphone by adjusting the rear gain trimmer for correct reading on the front signal meter

 

Level Control
You can also assign which outputs will be turned on or off by the front panel switch.
The switch function can be disabled if required.

To configure the unit switch off power, remove the top cover and adjust the jumper links as shown.
Avoid the power supply components shown greyed out on the diagram.

 

Remote Control
For each output you can select whether the level is controlled by the front panel control or by remote DC voltage. 
Note that this does not affect signals which are routed through the DIRECT path to the outputs.


Ducking
(internal ducking and external ducking)
Internal Trigger Select
Output ducking Select
Ducking Parameters

Depth can be set relatively shallow (-10dB), normal (-20dB) or to turn off the signal (MUTE).
Release time is either fast or slow.


Phantom Power
Lo-Cut Filter

 

---------------------------

 

To configure the unit switch off power, remove the top cover and adjust the jumper links as shown in the user guide
Avoid the power supply components shown greyed out on the diagram.

If you require further infomation please contact your dealer or local distributor

 




keywords: jumpers user options GR-05 GR5 mute switch enable zone level control switch zone select remote control