Knowledgebase:
ZED Series. How to set up GarageBand?
Posted by Jamie Lynch, Last modified by Maf Prigg on 11 February 2014 04:12 PM

With the ZED mixer disconnected from the Apple Mac, start a new GarageBand session, 
delete any audio tracks to create a blank template
(highlight track then click ‘
Track’ and select ‘Delete Track’).


Plug in the USB cable from the ZED into an available USB port on the Mac,
a prompt window will appear on screen informing the USB Audio CODEC has been recognised
and it will ask if you would like to use this device, select YES 
this will configure the ZED soundcard as the input and output audio device for GarageBand.


This can be checked in the GarageBand ‘Preferences’ page under the 'Audio/MIDI' tab and should look like this:

Audio Output: USB Audio CODEC
Audio Input : USB Audio CODEC


Close the ‘Preferences’ page
then create a new ‘Real Instrument’ using the ‘Add Track ‘ option.



The ‘Input Source’ setting in the ‘Track Info’ window on the right side of the screen should display:

Stereo 1/2 (USB Audio CODEC)


Set the desired routing and recording levels on the ZED mixer then arm/enable the track to record,
once the track is armed the level meters should display the signal from the mixer,
if the signal level is low the gain structure may need to be adjusted from the mixer.

With the levels set, hit 'Record' on the 'Transport bar' to commence recording.


Once the recording is complete, hit ‘Play’ on the 'Transport bar'
to playback the recorded audio on the ZED mixer USB return / playback channel.






keywords: Apple Garage Band SetUp Zed-10 Zed-14 Zed-24 Zed-10FX Zed-12FX Zed-22FX Zed-420 Zed-428 Zed-436 Zed-16FX zed-18 Zed60-10FX Zed60-14FX Zed-R16
Zed10 Zed14 Zed24 Zed10FX Zed12FX Zed22FX Zed420 Zed428 Zed436 Zed16FX zed18 Zed6010FX Zed6014FX ZedR16 Apple ios ipad